| Crop
Sensing Eye Kit |
|
The hay
indicator senses hay on the balers pick-up automatically,
starting and stopping the application.
Part #
474A Hay Indicator Kit for use with 464
Automatic
Control, 2005 & newer Automatic & Electronic Controls
|
| Flow
Meter |
|
Digital
Electronic Flow Meter
for use with any Harvest Tec preservative applicator
delivering between 40 and 500 pounds per hour. The flow
meter reads the application rate in pounds per hour and
total pounds used. |
| Moisture
Tester |
|
Delmhorst
FX-2000, Digital Hay Moisture Meter measures moisture
levels in the windrow and standard bales.
Features:
- Microcontroller circuit
- Can be used for on-the-go moisture
monitoring or as a portable meter
- In continuous mode:
- Takes two readings every
second
- Displays the average and
highest of eight accumulated readings
- Readings updated every 4
seconds
- Back lighted display
- In portable mode
- Averages up to 100 accumulated
readings
- Displays average and highest
of accumulated readings
- Measures moisture content over
the range of 6%-40%
- Ideal for high volume producers
who need the time-saving convenience of on-the-go
monitoring
|
| Transfer
Pumps |
|
|
To transfer Baler’s Choice Hay Preservative safely
and easily from your storage container to your applicator
tank, use any of the following transfer pumps:
Model 9214: For a rapid transfer rate
of 14 gallons per minute, this 12-volt unit can get the
job done quickly.
Model 9212: This standard output, 12-volt
model, will transfer preservative at a rate of 4 gallons
per minute.
Model 9213: This inexpensive hand transfer
pump is ideal for transferring small amounts of preservative
easily. |
| Floor-Mounted
Applicator Pause Switch |
|
|
The floor-mounted applicator
pause switch is an inexpensive addition to your application
system the enables the operator to easily stop and start
the applicator. For use with any automatic application
system, 2005 and newer. |
| Dye
Sprayer Marking System |
|
The Dye Sprayer Marking
System is a simple way to visibly mark the wet areas
on your large square bales. Compatible with the Model
596 Automatic Applicator or the Model 500 Moisture Monitor
for any large square baler, the 3-gallon system is mounted
near the bale chamber and when the adjustable high moisture
alarm sounds, the system will spray a red-colored, food-grade
dye on the exact location on the bale for a quick and
easy reference. |
| GPS
Interface Kit |
|
By incorporating the
GPS into the Model 500 Moisture Monitor, 596 Automatic
Applicator, or Bale ID Tagger, the producer has the ability
to create yield maps for their crops, allowing them to gain the knowledge needed to maximize productivity. The kit
consists of a removeable data storage card and GPS interface
harness that is compatitble with the Trimble 162 AgGPS,
which is purchased separately from a Trimble dealer. |
Kuhn
Brochure
